I connected the flash (USBest) and the device was recognized as FABULK device.Īnd when i pressed start, shows the code 0xa2 with 0MB capacity When i tried MPTool (UT163 Multi-Devices Production Tool) v3.9.80.0 and other version of this soft, I followed these steps:Ģ. Anyway i tried "Autorun Manager" and the device cannot be found by the utility. I tried this version of UT165 UFDUtility v3.2.4.0 and i didn't try the version of the soft that U send with the link īecause it was impossible to be extracted from WinRar or 7zip. Nothing happens when I click Start All buttonĬan anyone offer any assistance? Did I miss a step? Did I download the wrong program?
#Chipsbank format tool v2.8 manual#
In the Manuf Setting tab, change the Flash Setting information to select Manual and select (different versions) of 4 GB drive types. In the Manuf Setting tab, change the Product Information section to the info above (VID/PID/serial#) I've tried this for every manual selected 4GB type there was, but I can't seem to get it to work. I opened the RAR and doubleclicked on the UdTools.exe file to execute bring up the application with the title 8209/6208E Tools(Version 1.1.1.5). Chip Genius 3.0 says:ĭevice Name: +++USB Mass Storage Device(CBM USB 2.0 USB Device)(CBM USB 2.0 USB Device)ĭevice Type: Standard USB device - USB2.0 Full-Speed (USB1.1)Īlmost every combo for 1221/3234 in iFlash says Ameco_MW8209_6208E_1.1.1.5_20091015.rar.
Got a 4GB (1GB CDROM and 3GB free) USB drive from BigFix. Here are the error-codes the USBest-tool throws :Ġx10 Disk can't be formated as the selected file systemĠx11 Disk mounted flash chips doesn't match the settingĠx54 Firmware version mismatch with controller typeĠx58 Bad block count of table is not match with number of scanned bad blockĠx92 Source folder doesn't exist or source file is missingĠxa1 Size of source files is large than partition size during runningĠxa4 Size of source files is large than partition size